Item #: CCRC
Manufacturer's Item #: RED-COAT
CCI RED-COAT Blockout Fluid
Water Removable Blockout designed to fill pinholes and other blockout tasks when making screen printing stencils.
This product is a medium viscosity, water soluble red blockout designed to fill the open areas of the screen not covered by the emulsion. Use for masking several designs on a screen until ready to print or for multi-color work.
1. When the screen is dry and free of contaminants, pour ULTRA-BLOCK� on the print side of the screen. Spread over the open areas of the screen until completely filled.
2. Touch up all defects, including heavy blobs which tend to dry on the outside and pop off or smear during printing. Where very fine meshes are used, you may reduce the viscosity by adding a little water.
3. Remove any excess blockout with water.
Customer Reviews
There are no reviews for this item. Be the first and
add your review now!
Customers Who Bought This Item Also Bought
Item#: PELLON2
Pellons are sometimes called "Test Squares. Pellons are used for multiple color ...
Item#: TI1170
Tri-Flex 1100 Series plastisol, is formulated for direct wet-on-wet printing of ...
Item#: SCR2024
Normally used on manual presses.
Item#: ULQX1
QX-1 is a blue-green, ready-to-use, fast-exposing SBQ-dual-cure direct emulsion.
Customers Who Viewed This Item Also Viewed